- Use with Diversey J-Fill QuattroSelect chemical dispensing system
- Concentrated, one-step, EPA-registered disinfectant cleaner and deodorizer
- Kills HIV-1, VRE, MRSA, GRSA, MRSE, VISA, PRSP, Herpes Simplex Types 1 & 2, Influenza Type A2, Adenovirus, Rotavirus, and many more
- 10 minute contact time
- Kills the organisms that cause odors and works as an odor counteractant to further eliminate odors not associated with bacteria
- Highly concentrated quaternary formula provides excellent one-step, cost-effective cleaning and disinfection
- Use solution is neutral to floor finish so it will not dull, pit, or soften floor finishes
- Minty fragrance
- 2 liter concentrate bottle yields 170 ready-to-use gallons
Diversey Virex II 256 Disinfectant Cleaner – J-Fill – 2 x 2.5L/Case
$49.10
The Virex II 256 is a one-step quat disinfectant cleaner used in healthcare facilities where cleaning and prevention of cross-contamination are critical. Kills a broad spectrum of organisms and their odors.
10 in stock
Description
FEATURES
GENERAL USE DIRECTIONS
Dilute Diversey Virex II 256 Disinfectant Cleaner Concentrate using the J-Fill QuattroSelect dispenser into a properly labeled bottle or bucket.
- Apply solution to hard, nonporous environmental surface.
- All surfaces must remain wet for 10 minutes.
- Air dry, wipe surfaces to dry and remove any residue, or rinse with potable water as necessary.
- Rinsing is not necessary unless floors are to be coated with finish or restorer
- All food contact surfaces such as appliances and kitchen countertops must be rinsed with potable water.
- Do not use on glassware, utensils, or dishes.
- Apply solution to hard, nonporous surface.
- Air dry, wipe surfaces to dry and remove any residue, or rinse with potable water as necessary.
Non-Acid Bowl Cleaner/Disinfectant
- Empty toilet bowls by forcing water through the trap.
- Apply solution to exposed surfaces in toilet bowls and urinals.
- Swab entire surface area especially under the rim.
- Allow entire surface to remain wet for 10 minutes.
- Flush toilet or urinal and rinse swab applicator thoroughly.
Clean/Disinfectant Shower & Locker Rooms or Open Area with Floor Drains
- Apply solution to floors, walls, and ceilings.
- All surfaces must remain wet for 10 minutes.
- Scrub and rinse surfaces thoroughly and let air dry.
- Apply solution to hard, nonporous environmental surfaces.
- Allow surfaces to remain wet for 10 minutes.
- Wipe and let air dry.
To Kill Mold and Mildew
- Apply solution to hard, nonporous environmental surfaces.
- Allow surfaces to remain wet for 10 minutes.
- Wipe and let air dry.
To Control Mold and Mildew
- Apply solution to pre-cleaned hard, nonporous environmental surface.
- Allow to air dry.
- Repeat weekly or when growth reappears.
Reviews (0)
Reviews
There are no reviews yet.